Jump to content
“LET’S GET WET!” GROUP BUILD STARTS JAN 1, 2023 ×

Search the Community

Showing results for tags 'u-boat scout'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • LSM Info, Chat & Discussion
    • Important Information and Help Links for LSM
    • General and modelling discussion
  • LSM 'Under Construction'
    • LSM Work In Progress
  • LSM 'Completed Work'
    • LSM Armour Finished Work
    • LSM Aircraft Finished Work
  • Non-LSM Builds
    • All Non-LSM work, WIP and completed
  • LSM Marketplace
    • Buy, sell, swap, seek
    • LSM Vendors and Sponsors
    • LSM Reviews
  • LSM Competitions
    • Archived GB's Sub Forum
    • Everything Ukraine Ready for Inspection

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 1 result

  1. My plan is to crank this out by November then start something really big. The Fa330 always interested me as a unique aircraft with an equally unique mission. This was towed by a U-Boat so the pilot could see beyond U-Boat horizon view and report any enemy activity. Finally there is a lot of rigging and I will use either RB or GasPatch turnbuckles. This will get me feeling comfortable for my WNW build, next on the bench. That's right Kiwi Mike...no typo here. 30 minutes into this build I was already regretting this. This aircraft is mostly tubular and the parts are typical short run injection. Loads of flash and seams. Cleaning these tubes are going to drive me batty. So I will cut all remaining tubular parts from .5mm, .4mm and .3mm styrene rod. This will actually be easier than cutting from sprue and cleaning. Building balsa wood and tissue models experience will come in handy. Resin main control pully wheel (feel free to correct me on correct definition) and control stick installed with epoxy. I also wrapped the control stick handle with .2mm lead wire. A brush coat of paint will give the handle a ribbed appearance. Spar and 4 sub control pully wheels are cut from styrene. More fun with .5mm and .4mm styrene rods. The rudder gets a .4mm rod on both sides and will be sanded down and this was fabric. Will also add grab handle I cut out at top of rudder.
×
×
  • Create New...