Jump to content
Playing in the Sandbox Group Build Sept 1, 2024 - Jn 1, 2025

Vegas convention 2021


harv

Recommended Posts

Thanks guys for the pics, I was watching a Vendor Room walk through on YouTube, didn’t seem many people around, if that was Telford you wouldn’t be able to down the aisles. You tend to shuffle around Telford because it’s so damn crowded……Looks a great show……..

Link to comment
Share on other sites

On 8/19/2021 at 7:58 PM, harv said:

I'll find out tomorrow. Was the Norton Sound ported at Maggoo ?......harv

It was in Port Hueneme at the Seabees base but it was used for NAS Point Mugu. 
it was used For Polaris, Polaris  II, tomahawk, regulus, and a few others. 

  • Like 2
Link to comment
Share on other sites

I'm glad everyone enjoyed the pics. My thoughts on the convention; the club that put it on and sponsored it, hats off. You did a great job. The show was fantastic with more models than I've seen befor. I heard they broke a record. I was a bit disappointed in the vendors room. No real big names there. I did reconnect with Mike Valdez from Sierra Hotel resin. Been a few years since we last talked. Great guy. Meet a new friend, one of Danny's coharts. Now my big grip. Rio Hotel. It ducked. Rooms were old., no microwave.  Just not great. Housekeeping didn't clean the room one day. No room service. And Bev is on the phone right now with them about a $180 charge on our bank card we didn't use. Also, I dint spend a cent while we were there. Mike was the only one I knew there so that was a disappointment. Ok, I'm done now. I am looking forward to Omaha next year. I hope a bunch of us can get together.....harv

  • Like 3
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...